3D model of a necklace representing a skeleton
We tried to keep the necklace small but if you will find some issues with the 3D printing, just remember that you can scale it up a little bit. For the assembly of the skeleton, you can use thread or small rings. We used thread and we don’t believe that they will hold for long. Of course, more free designs and models for 3D printing are available on our site.
Supports or rafts
This part does not need supports or rafts.
Use of one perimeter line. When the designs are complicated, the use of one perimeter line is recommended because more than one could leave holes on the part.
High layer height, i.e. 0.25 mm for a 3D printer with 0.4 mm nozzle, since it does not affect any detail of the part.
Medium printing speed, but low printing gap speed.
Medium travel speed but try to avoid oozing effect and select the right printing temperature because the parts of this model are very close to each other.
DOWNLOAD DESIGN (0.96$): Link
(1x) PLA filament
- Cupcake-Muffin – Zombie Hand 4
- Cupcake-Muffin – Zombie Hand 3
- Cupcake-Muffin – Zombie Hand 2
- Cupcake-Muffin – Zombie Hand 1
- Cupcake-Muffin – Tree