3D model of a pot for 3D printing
Supports or rafts
This part does not need supports or rafts. The last layers of the object have been designed as a bridge and not as a dome. Also, the bridge is inside and therefore there is no point to waste material.
Three lines perimeter.
Low layer height, i.e. 0.1 mm. It affects mostly the last layers, which is the bottom of the model. A higher layer can be used, but it will not make a nice bottom surface (or top during 3D printing). However, because the object is placed upside down, you will not be able to notice this detail.
High printing speed, with low to medium gap speed. However, the high speed can create perpendicular stripes on the object due to the vibrations.
Download Design: Link
(1x) Carbon filament
(1x) PLA filament